RAPTOR MAGNET QUICK START

This quickstart guide is designed for a first time users!

What’s in the box

  • 1 – Raptor Magnet
  • 2 – Mitchell Wrench
  • 3 – Lemo to Dtap Power Cable
  • 4 – V-mount Battery Plate
  • 5 – Steel Plate
  • 6 – Universal Plate Mounting and Screws Package (8x M6 screws, 4x M8 screws, 4x 1/4-20 screws)

INSTALLTION

Step 1: Install camera stabilizer mount to Universal Plate

 

Step 2: Install all to Steel Plate by 8x M6 screws

 

Step 3: Install power cable and battery

  • PWR LED: Power Status (LED ON – Power on, LED OFF – Power off)
  • LOAD LED: Magnet Status (LED ON – Magnet is working, LED OFF – Red Button is pulling, Magnet is off and camera is released)

 

Step 4: Remove the “REMOVE TO FLIGHT” key

NOTE: Lock the “REMOVE TO FLIGHT” key again if you have not shot, avoid someone accidentally pulling the button.

 

RAPTOR MAGNET IS READY

Touch Steel plate set to the magnet until you hear “CLICK” and LOAD LED is ON (failsafe is ready).

Pull RED button to release camera set.

WARNING

  • Double-check battery power has enough capacity during shooting
  • After setting up the gimbal stabilizer, camera, lens, and more underneath the Raptor Magnet, you should lock the “Remove to flight” key to protect the devices from unexpected collision accidents.
  • Check the light signal (both lights are on when everything is ready)

WHAT’S MORE?

How to mount Raptor Magnet with Vibration Isolator?

Raptor Magnet supports Mitchell-based, allows you to mount under vibration isolator easily.

FAQ RAPTOR MAGNET BLOG